Separate names with a comma.
Discussion in 'Water Fed Pole Cleaning' started by Tuffers, Oct 17, 2012.
Mine is reading 001. What's the maximum reading before the resin needs changing?
I've used 12 with no problems .
But the majority say change at 10 .
i change mine at 10 ppm and never had any complaints i did once go to 18 ppm by mistake and still never got any complaints
Ahh, cheers guys. I live in a soft water area and take the water with me, but I work in a hard water area. Will the hard water 'kill' the resin if I fill up with it? I take my vessel with me incase I need an emergency fill up btw.
If the tap tds is higher, it will use up the resin faster, but if the water is supplied by the same board, I can't see why it would be much different.
Different water boards mate, but I get your drift.
some people say 10-20 after that it goes down hill pretty quick as you know that you lengthen the life if you was to add a RO to it
dont use after 10
Trust me, the TDS can vary hugely even in the same area with the same water board. My reading is 352-354, but my Mums less than half a mile down the road is 199-201, which is why I rigged my RO system up at hers lol. Reckon my tap water's comin direct from the sewer lol
Now that I have my new TDS meter , i just tested our tap water and it reads 149.