New Facelift controller fitted, pump not turning on

[Brandon]

Just fitted my new Facelift digital pump controller, followed the instructions carefully so all the wires are hooked up properly.

Turned it on, held Up and Enter to calibrate. Pressed down

to Auto Calibrate and then Enter and it flashes:

“Aut - C 99 - Err - PS” and then keeps flashing “Err - PS” on a cycle.

I’ve disconnected the hose to the reel as I thought it might be air in the system and I’ve sucked on the hose until water comes out.

I’ve checked all the wiring and it’s good.

Any suggestions would be much appreciated!

 

[kevinc250]

from what i remember about the spring controllers ps indicates power supply-easiest option is to put the battery on charge,at least if that doesn't work then you'll know that you have a fully charged battery

 

[kevinc250]

sorry,got that wrong-again,thats why i don't use them spring controllers-heres a link to problem solving them

http://springltd.co/support

 

[kevinc250]

have a look at the section headed controller messages and i think you may find your answer

 

[Brandon]

have a look at the section headed controller messages and i think you may find your answer

Thanks for your help Kevin. Turned out it was the wiring in the end! The crimp connectors they send, you need to squeeze them really hard with pliers to make the metal splice the wire. Works a treat now.
Thanks again.