Jump to content

Don't want to see ads? Become a subscribed member.

First di only use.


Stevo66

Recommended Posts

Morning all. After starting off with an ro/di system we decided to change to di only because of time filling using the ro/di.

Connected di vessel hosepipe in and outlet to tank to fill 400l tank. After filling i did a tds check and the readings are 002. Did this 3 times and all came back as 002. Ro/di readings are always 000. My starting tds is 34.

Shouldn't the di vessel,as its new with new resin,bring it down to 000 or is 002 OK to clean with? Don't want to upset customers.

Have I done something wrong when connecting or is this pretty standard?

Appreciate any advise.

Link to comment

002 is fine to clean with, regarding not getting it to 0 my first thoughts are you're putting it through the DI to quickly. Why not double DI it then this will be easily resolved.

Link to comment

As @Part Timer says, run the tap flow slower and the longer the contact time the water has with the resin, the lower the tds will be. I double Di and highly recommend if you want to fill faster, but single Di if you fill slowly.

Link to comment
  • 2 weeks later...

My main unit is ro/di but just wanted a solution to produce 100l to 200l of water if and when needed. Purchased a small 4.6 vessel as didnt need anything big. Unit came fully filled from bayersanukltd. My start tds is quite low reading 34. Fordt fill of 400l went to 002. I produced approx another 100l of water while out on round and tds as now rocketed to around 17 to 24. This as produced 500l of water in total. Resin calculator estimates 4.6l vessel,would produce approx 2400l of pure water before resin would need replacing. Are my calculations correct because 500l of water to replace resin is going to work out expensive.

Link to comment
1 hour ago, Stevo66 said:

My main unit is ro/di but just wanted a solution to produce 100l to 200l of water if and when needed. Purchased a small 4.6 vessel as didnt need anything big. Unit came fully filled from bayersanukltd. My start tds is quite low reading 34. Fordt fill of 400l went to 002. I produced approx another 100l of water while out on round and tds as now rocketed to around 17 to 24. This as produced 500l of water in total. Resin calculator estimates 4.6l vessel,would produce approx 2400l of pure water before resin would need replacing. Are my calculations correct because 500l of water to replace resin is going to work out expensive.

It depends on what resin has been used and I guess if you open it that it will be half full.

Link to comment

Don't want to see ads? Become a subscribed member.


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Ad Blocker Detected

Please disable your ad blocker

Our forum relies on ads to pay for the servers and our time maintaining and running the forum.

Sadly running a forum like this is not free, and due to our popularity, we need servers that can handle the amount of traffic and resources our forum uses.

 

If you do not wish to see ads on our site, please consider supporting the forum with a membership subscription.

 

Accept