Kleenwell
Well-known member
- Messages
- 124
- Location
- Weston super mare
Hi all
i have just upgraded to a liquidlogic v11 Rf controller (previously simple analog controller). It works great on wash mode but as soon as I up the speed (rinse mode) it goes dead end and pulses. I have set the calibration to 99. The highest it will go. But it still does it. Worse if I lower the calibration. If I disconnect my hose and run straight back into my tank, it’s fine. Any ideas peeps?
i have just upgraded to a liquidlogic v11 Rf controller (previously simple analog controller). It works great on wash mode but as soon as I up the speed (rinse mode) it goes dead end and pulses. I have set the calibration to 99. The highest it will go. But it still does it. Worse if I lower the calibration. If I disconnect my hose and run straight back into my tank, it’s fine. Any ideas peeps?
Last edited by a moderator: