SkulBlaker
Well-known member
- Messages
- 412
- Location
- Scotland
hey guys, bit of advice if possible. Been using a liquidator for a while now and over the past couple of months have been getting lines on the turns from the tips of the rubber, tried different rubbers and cutting them with very sharp scissors, but the lines still happen, even on the pre cut end.
Don't understand why it's happening, am I needing new channels... liquidator tips? Or is it something else. Using GG4 and a dash of Ecover in the solution but still occurs if I'm using one or the other or both.
Don't understand why it's happening, am I needing new channels... liquidator tips? Or is it something else. Using GG4 and a dash of Ecover in the solution but still occurs if I'm using one or the other or both.