Separate names with a comma.
Discussion in 'Water Fed Pole Cleaning' started by Belfastcleaning, Mar 19, 2013.
Where is best to drill the floor so I can put a hose port thing on the bumper?
Get the reg plate ports lol. There cool as...
Right over the fuel tank!
try and look at other transit installs mate.
But yeah id be tempted with van number plate thingy!
First check which is the priority rear door on your van. Ours are the offside door but Vivaro's use the nearside door. I would recommend you use the other side to exit your hose. If you don't you will be forever tripping over the hose from the port to your hose reel. Once you have decided which side the port must go, then identify a section of floor close to the rear door support pillar. You are looking for section of floor that isn't boxed in with chassis supports. Make sure that the exhaust won't interfer with the hoses and the holes are not too close to the back as they could easily kink on the bend.
As the spare wheel is located under the back, you need to be well clear of that as well.
i seen a van other day kid had banged a hole in the back wing and fed his pipe threw it lol looked like hed used a hammer and nicker lol
I got a company van Renault Kangoo.
I drilled a hole on the rear of each side of the van floor and cable tied them nice'n'neat underneath the bumper.
Total price.......£2.00 for two connectors from B&Q.....job done .
These are the connectors I used....£1.00 each ....