iluvwindows
Well-known member
- Messages
- 392
Hi All
My pump flow is really low and it keeps flash DE anyone know what zee problem is??
My pump flow is really low and it keeps flash DE anyone know what zee problem is??
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: this_feature_currently_requires_accessing_site_using_safari
Hello, ive got this dead end issue, ive tried the steps you discribed, so far so good... thanks for the solution.... now i was wondering and hope someone can awnser my question, what's the standard CALL SENSITIVE setting? I raised with steps of 5, now it's on C55 and the flow is 80, so far so good, battery is 11.4Volts... can i just leave it like this C55? Sorry for my noobisch question, it's new for me, this system... thank you in advance...DE is short for Dead-End which is electrical engineer 'speak' for shut-off sensed. DE should be displayed when you have turned off the flow of water to your pole using a flow valve or similar. DE will be displayed until the flow is turned back on again.
However if you are getting DE during use when you have not turned off such a valve then this means that your Dead-End calibration is not set to the right setting (too sensitive). If you look in the instructions that came with the unit you will see on page 2 that it shows how to change this setting. Simply put, press and hold the two outer buttons until CAL is displayed. Then a number will show which is your current shut-off point. If the unit is shutting off too often then you will need to increase this number by increments of 5 at a time. Then press the right hand enter button and SET will display.
Try the system out again and see if it works if not repeat this step until it does not dead-end during use
Thanks, gues you have a point there, problem is i don't know what setting it was on before i got this dead end signal... i also had my battery very empty, so i am charging as we speak to get it back on 12Volts, i'm at 11.5V now.. as soon as i lower the CALL under 50 it gives me again dead end signal... i better leave it like this then, i was afraid maybe the setting would be to high and i force something.... but hey, the windows are shiny ..all good ? again thx for the replyThere is no standard setting as everyone's system is a little different so different bore hose etc and I would imagine it's quite a bit colder in Holland this time of year so higher settings than the UK may well be needed.
Thanks, gues you have a point there, problem is i don't know what setting it was on before i got this dead end signal... i also had my battery very empty, so i am charging as we speak to get it back on 12Volts, i'm at 11.5V now.. as soon as i lower the CALL under 50 it gives me again dead end signal... i better leave it like this then, i was afraid maybe the setting would be to high and i force something.... but hey, the windows are shiny ..all good ? again thx for the reply