Another question?

[francie]

The flow controller went on my backpack so I just bought a new backpack, the pump an switch an charger work fine, iv taken it apart, I want to rewire back together in the yellow box an use it for chemical spraying. 

Is it possible to rewire without the controller, jump pump, on/off switch, charger an fuse? 

Or can I just wire battery to pump an on/off switch? 

Thanks

 

[spruce]

The flow controller went on my backpack so I just bought a new backpack, the pump an switch an charger work fine, iv taken it apart, I want to rewire back together in the yellow box an use it for chemical spraying. 

Is it possible to rewire without the controller, jump pump, on/off switch, charger an fuse? 

Or can I just wire battery to pump an on/off switch? 

Thanks

If you are asking this question then maybe you should consider not doing the job.

You will need a fuse for protection.

You will need a switch to switch the pump on and off.

You will need the charger point to plug the charger in to recharge the battery.

You don't need the flow rate controller - the pump will run flat out.

 

[francie]

If you are asking this question then maybe you should consider not doing the job.

You will need a fuse for protection.

You will need a switch to switch the pump on and off.

You will need the charger point to plug the charger in to recharge the battery.

You don't need the flow rate controller - the pump will run flat out.

I have to learn somewhere @spruce?

I'm pretty good with my hands, I just need a wee diagram or something to see we're wires are attached. 

I have all of the above I just need to connect them together. 

I just jubed on ?? il take the cover of my new backpack an get a look. 

 

[francie]

I have to learn somewhere @spruce?

I'm pretty good with my hands, I just need a wee diagram or something to see we're wires are attached. 

I have all of the above I just need to connect them together. 

I just jubed on ?? il take the cover of my new backpack an get a look. 

@spruce with a bit of trial an error iv managed to rewire it all back together without the controller.

On/off switch, charging point,fuse all working, just need to go get few spades an tape tomorrow an connect it properly.

Iv used a 4foot length of orange hose an attached the mesh filter than was in the bottom of the backpack tank to the end of the hose, so this will drop inside the barrel to draw up. 

Il put a few pics up for the craic, give yous a look. 

 

[francie]

If I upload a picture, will yous guys be able to see the rest of my pics on phone? 

Or will it just be the one I upload? 

Thanks

 

[Wind o kleen]

If I upload a picture, will yous guys be able to see the rest of my pics on phone? 

Or will it just be the one I upload? 

Thanks

Just what you upload mate lol