Morning all,
Just finishing off a fresh install but having trouble with pulling the water through.
I’ve got a 350l tank, 1/2 inch hose to 100psi shurflo pump and then pump to electric hose reel, then to v16 basic controller.
As there’s no water going through the system yet, how do I get it started? I’ve turned the controller on and tried auto calibration but it’s not sucking through any water. The pump isn’t engaging either. It was working fine yesterday in my other system, I’ve just taken it off and put it into this new set up.
Electrics hooked up correctly, checked and rechecked. This is the third system I’ve installed in my vans but can’t remember how I got it to start from scratch.
Is there a trick or something obvious that I might be missing?
Cheers
Just finishing off a fresh install but having trouble with pulling the water through.
I’ve got a 350l tank, 1/2 inch hose to 100psi shurflo pump and then pump to electric hose reel, then to v16 basic controller.
As there’s no water going through the system yet, how do I get it started? I’ve turned the controller on and tried auto calibration but it’s not sucking through any water. The pump isn’t engaging either. It was working fine yesterday in my other system, I’ve just taken it off and put it into this new set up.
Electrics hooked up correctly, checked and rechecked. This is the third system I’ve installed in my vans but can’t remember how I got it to start from scratch.
Is there a trick or something obvious that I might be missing?
Cheers