RO system ppm tee valve

[Den]

Thanks mate only just noticed very, very slight only noticed because I think adamangler mentioned on another thread that his ppm went up if RO and Di had slight leak so thought I would check and noticed smallest amount of water on one of the tee joint.

 

[Dave B]

Take the pipe out and check it..if necessary cut the end straight and reconnect and make sure it is pushed fully in

Should be ok

I haven't had any t pieces leak unless the pipe end has been bent or damaged

 

[Den]

I have quite a lot of spare tubing so will make a new length.

 

[Dave B]

Just take a few mm off the existing one..

 

[Damo]

Drawn up the diagram last night ready for when I move the system.

12v timer/relay/solenoid. Easy peasy ish :rofl: