wagtail

[bazzer]

well after getting a wagtail flipper i can say it is a good tool and after putting liquidator channel on it its great the only negative thing i came across is the pad a bit small and when i flip it back after a few goes the pad flies off as if plastic clips arent firm enough anyone else have this problem ( daveyboy boarcity ) can you help cheers

 

[Duncs]

i took the pad of and just used it normal

great for doing shops

 

[Dave B]

I sowed a strip of velcro on the pad with the sowing machine as it holds a whole lot better to the clips

 

[bazzer]

thanks for that guys will try the velcro daveyboy can see the potential in this tool when i get proper use to it

 

[Dave B]

This is my one

You can see the velcro on here

Also it stiffens the ends up as they flap about on the liquidator channel as i cut the velcro clips down to fit between the handle and liquidator clips

[media]

[/media]

 

[bazzer]

nice one mate will have a go at that looks sound thanks

 

[mark]

look at waggas vids.drill to holes either side of the disk.use an old applicator sleeve.cut it in half.thread a biycle spoke through the applicator(some stitching required)& cable tie it on.job done.

 

[Dave B]

No need with velcro on the scrubber

Wagga is a whizz with a wag but i have tried both ways and my way works perfect for me

I learnt from Bob Hatt (polzn bladz ) how to use a wag on a pole and honestly for me there is no need to faff about with metal rods etc

 

[Eric Gilliand]

well after getting a wagtail flipper i can say it is a good tool and after putting liquidator channel on it its great the only negative thing i came across is the pad a bit small and when i flip it back after a few goes the pad flies off as if plastic clips arent firm enough anyone else have this problem ( daveyboy boarcity ) can you help cheers

I just turn the pad around. The dark blue edging adds a little more bulk and I prefer the rounded edges at the channel anyway. Ignore my handle mods...it's still a Wagtail..."just not as we know it Jim"

View attachment 6528