heyoh
Well-known member
- Messages
- 242
Recently I purchased one of these:
http://www.daqua.co.uk/ro_systems.htm
@doug atkinson
4021 with sediment+chlorplus10 prefilters
So far while testing I got:
600ml waste to 150ml so that's 1 pure to 4 waste - if i'm correct
turning the valve and reducing waste didn't give much more pure, so I'm guessing that this will be the efficency I will have to live with...
My tap TDS is ~300ppm, pressure is about 40psi (before prefilters)
http://www.daqua.co.uk/ro_systems.htm
@doug atkinson
4021 with sediment+chlorplus10 prefilters
- Will it cause any problems if pure outlet is physically lower than inlet on the tank?
- How do I know what is the best ratio of pure/waste?
- After backflushing how do I find this 'ratio' again easily? Do I have to measure water from waste and pure every single time?
So far while testing I got:
600ml waste to 150ml so that's 1 pure to 4 waste - if i'm correct
turning the valve and reducing waste didn't give much more pure, so I'm guessing that this will be the efficency I will have to live with...
My tap TDS is ~300ppm, pressure is about 40psi (before prefilters)
Last edited by a moderator: