I bought one of those wirelss controllers with key fobs and when it arrived the diagram shows that the remote box should be wired between the battery and the pump, thus allowing me to control the flow and turn the pump on and off. I e-mailed the company and explained that my system, like most others, sees the logic controller wired to the battery and then from the controller all other components are wired. Therefore battery to liquid logic/ varistream, or whatever controller you use, then from that to pump(s) auxillary battery if you have one, tds readings if built in and so on.
my question to the supplier was where dies their wirelss controller go as there is no direct link from the battery to the pump. They told me to bypass my Liquid Logic controller but I explained this was not possible as theier controller only controlled flow and not calibration etc.
To my surprise they had no other answer.
Does anyone of you clever people have the answer.
Do I cut the wires from my LL controller then between that and the pump add the wireless controller? If so assume the original LL controller would overide the wireless controller.
Please help, any ideas
my question to the supplier was where dies their wirelss controller go as there is no direct link from the battery to the pump. They told me to bypass my Liquid Logic controller but I explained this was not possible as theier controller only controlled flow and not calibration etc.
To my surprise they had no other answer.
Does anyone of you clever people have the answer.
Do I cut the wires from my LL controller then between that and the pump add the wireless controller? If so assume the original LL controller would overide the wireless controller.
Please help, any ideas