Dale H
Member
- Messages
- 9
Hi everyone,
I'm hoping some of you kind souls could help with an issue I have. My water tank is in a sealed unit, therefore, I can't physically see how much water is in it, but attached to the outer unit is a clear pipe which fills as the water fills the tank. Within the clear tube/pipe is a ball bearing which is supposed to float so that I can see the water level, however, the (plastic) ball bearing has become lodged at the bottom of the pipe. This has now caused a blockage, so I can't even see the correct water level. I've already taken the tubing off the tank once and dislodged the ball bearing but within a week it has become lodged again. Any recommendations of how I can prevent this from happening again? Thinkinkg of just removing the bearing altogether. Thanks in advance for any advice you could provide.
Cheers,
Dale
I'm hoping some of you kind souls could help with an issue I have. My water tank is in a sealed unit, therefore, I can't physically see how much water is in it, but attached to the outer unit is a clear pipe which fills as the water fills the tank. Within the clear tube/pipe is a ball bearing which is supposed to float so that I can see the water level, however, the (plastic) ball bearing has become lodged at the bottom of the pipe. This has now caused a blockage, so I can't even see the correct water level. I've already taken the tubing off the tank once and dislodged the ball bearing but within a week it has become lodged again. Any recommendations of how I can prevent this from happening again? Thinkinkg of just removing the bearing altogether. Thanks in advance for any advice you could provide.
Cheers,
Dale