11L DI Vessel - How much pure water will it produce?

[FD760]

I'm looking to purchase a 11L DI Vessel and just curious.

Approximately how much pure water would one of these pump on per hour?

My water is around 140/150PPM I know this may not be the most ideal method but I am on an extremely tight budget and work full time so I am just looking to start up part time and get the occasional job in and build up a round and if all goes well pursue it possibly full time.

Would it likely bring my water down to 0PPM or would I need to run it through two vessels ideally?

Thanks

 

[ched999uk]

Have a look here: Resin Calculator | GrippaTank Ltd
As for flow depends on your tap pressure.

 

[doug atkinson]

Approx 1500 litres

 

[Pjj]

Depends what’s going into it if it’s 002 a long time if it’s 100 not that long

 

[FD760]

Have a look here: Resin Calculator | GrippaTank Ltd
As for flow depends on your tap pressure.

I’ve used this to workout my resin cost already but just it’s the DI vessel I’m wondering how much water they allow through and produce per hour approx.

 

[FD760]

Depends what’s going into it if it’s 002 a long time if it’s 100 not that long

Hey, sorry what do you mean by what’s going through it? 002 or 100?

 

[FD760]

Approx 1500 litres

Is that per hour?

 

[Part Timer]

It's hard to tell you because the TDS is so high to start off with I don't think you'll be able to just fully turn tap on and run it through if you did I doubt it would get it down to zero.

 

[Pjj]

Hey, sorry what do you mean by what’s going through it? 002 or 100?

With a low reading the resin will last a long time as it’s not doing much , with a high reading it will wear out quicker as it’s doing a lot more work

 

[PC]

Double di definitely imo. But you will still muller the resin with that tds going through it

 

[doug atkinson]

No that’s total amount of litres produced