Eric Gilliand
Well-known member
- Messages
- 813
- Location
- Dunedin, New Zealand
...and yes the same stuff works fine on SS channels.View attachment 5784
this is what I used. Loctite also do a range of cold weld epoxies. has worked just fine on the Wagtail Aluminium channel. imagine it would work equally well on SS. ettore Brass? Not sure...
1. Make your cuts and adjust pedantically until you have it just right
2. Tape on back so epoxy doesn't foul up the inside of the channel
3. 12 hours, still pliable so rough trim with blade.
4. 24+ hours, file and sand
....now, I've got some Ettore brass tucked away somewhere...
View attachment 3784