Bobsonduggnutt
Member
- Messages
- 20
- Location
- Lanarkshire
Hi folks, I'll apologise in advance for a lengthy post but I think this might make an interesting discussion. I'm a newbie just starting my business and am currently looking at options for kitting my van out (2014 vivaro sbw) I want to build a decent window round but have the ability to take on power washing jobs out of the same van. I'm sure there are many schools of thought on this but I have been throwing around a few ideas and would love to hear your ideas. To start with I'm up north so my TDS from the tap is around 40 and I'll be going for a twin 27ltr DI setup for purification, however I'm unsure if it's possible to place the DI's after the tank in my van which I'll mention later??? Anyway here is what I'm thinking.
option1
A single 1000ltr tank filled from the tap, two outputs.....one feeding the power washer and one going to the DI's then then the pole. With regards to pumps here I'm not sure if I'd need a pump before the DI's and a pump after.
option 2
Two 500ltr tanks independent of eachother one for the washer and one for the pure. This is probably the obvious way to go but I'm on a bit of a budget haha
option 3
one 650ltr tank and a 350ltr tank. The 650 with two outputs...one feeding the washer and one going to the DI's then to the 350 then to the pole. I think this setup would be interesting as I could just open a valve to fill my 350 as needed but still have a big tank that I can fill straight from the tap for the washer.
Any thoughts you have on this would be appreciated, as I said earlier I'm a noob so I'm not even sure some of this stuff is possible ie. Filtering water as working etc.. I just want to be as diverse as I can to try and get off to a good start and get cash flowing.
option1
A single 1000ltr tank filled from the tap, two outputs.....one feeding the power washer and one going to the DI's then then the pole. With regards to pumps here I'm not sure if I'd need a pump before the DI's and a pump after.
option 2
Two 500ltr tanks independent of eachother one for the washer and one for the pure. This is probably the obvious way to go but I'm on a bit of a budget haha
option 3
one 650ltr tank and a 350ltr tank. The 650 with two outputs...one feeding the washer and one going to the DI's then to the 350 then to the pole. I think this setup would be interesting as I could just open a valve to fill my 350 as needed but still have a big tank that I can fill straight from the tap for the washer.
Any thoughts you have on this would be appreciated, as I said earlier I'm a noob so I'm not even sure some of this stuff is possible ie. Filtering water as working etc.. I just want to be as diverse as I can to try and get off to a good start and get cash flowing.